compaq proliant
Are you in search for more ram for your computer? Visit the web's largest online source for computer memory online. No matter what type of computer you have, we can help you find memory and learn to install it. Find here
You can think of RAM as an incredibly fast hard drive that stores information temporarily instead of permanently. When you start a program it is loaded from the hard drive into RAM. When a program is running in RAM it can run hundreds to thousands of times faster than it can if run directly from the hard drive. The problem is that the capacity of a standard hard drive is many times the size of a computer''s RAM size, meaning it is possible to load so many programs that the RAM can no longer hold them. When that happens, your computer''s virtual memory kicks in, and that''s bad. Virtual memory is simply your hard drive trying to act like a RAM chip. Since the hard drive is so much slower than real memory, programs stutter and sometimes crash when the hard drive has to do a job it was never designed for. There are only two solutions to this problem: close some programs until virtual memory is no longer needed, or add more physical memory. If you can afford it (and current memory prices are low enough that practically anyone should be able to), the latter solution is always preferable.
What is the difference between 2-clock and 4-clock memory? Two types of SDRAM modules are the 2-clock and the 4-clock module. Structurally, they are the same, but they are accessed differently. A 2-clock SDRAM module is set up so that each clock cycle accesses two chips on the module. A 4-clock SDRAM setup accesses 4 chips per clock cycle. To choose what kind to get, you must look into the motherboard''s documentation. 4-clock modules are the more commonly used. The typical indication of the wrong type being used is a system giving error beeps and not booting as it cannot use the memory installed. The system will not proceed past POST (Power On Self Test). 2-clock was only used in 66 MHz systems. All PC 100 and PC 133 memory is 4-clock only. Do all of your SDRAM modules use SPD? SPD, or Serial Presence Detect, is a program in an EEPROM chip on the modules of SDRAM (Synchronous Dynamic Random Access Memory). It tells the system’s BIOS what the specifications and settings of the memory module are. All of our SDRAM DIMMs have SPD programming. The system BIOS should therefore be set on AutoDetection for memory.
DIMMs (Dual Inline Memory Modules) look a lot like SIMMs, but they come in a 168-pin format. They are usually a faster and higher-performance memory than SIMMs, and are used in Pentium PCs. They come in capacities ranging from up to 64MB and beyond. Step 4: Parity Versus Non-Parity Chips A SIMM or DIMM usually has nine chips of memory on it. Eight of those chips are used for the memory itself. The ninth chip is called a parity chip. The parity chip is used for error checking, to make sure that the other chips aren''t making any errors. Some computer systems require parity chips, while others do not. In general, Pentium-based computers and certain 486s don''t require parity memory. Parity memory usually costs more than non-parity memory. Check your PC or motherboard''s manual to see which kind of memory your PC requires.
Find here - Are you in search for more ram for your computer? Visit the web's largest online source for computer memory online. No matter what type of computer you have, we can help you find memory and learn to install it.
compaq proliant
| home | compaq presario | zr50mc |
hostmaster@ram-memory-computer.com
All Rights Reserved. The products mentioned are trademarks of their respective owners and are not owned by us. Read our privacy guidelines.